That you perform switchover by entering the request interface With a Layer 2 circuit local-switching configuration, we recommend Of both the MC-LAGs and when both mc-ae interfaces are linked together Switchcover mode is configured on the aggregated Ethernet interfaces Setup using Inter-Chassis Control Protocol (ICCP) and nonrevertive If two MC-LAG devices configured in an active-standby
Time that triggers an automatic or manual switchover when the specified In nonrevertive mode, the link switchover In revertive mode, the link switchover is triggeredĪutomatically by using the request interface mc-ae switchover operational mode command. You can configure the link switchover in two modes: revertiveĪnd nonrevertive. Triggered and the control is switched back to PE1 even though PE2 However,Īs soon as PE1 is available again, an automatic link switchover is InĬase of any failure at PE1, PE2 becomes the active node. PE1 is configured in active mode making itĪ preferred node, and PE2 is configured in active-standby mode.
Node even when the active node is available. With this configuration, you can trigger a link switchover to a preferred In active-standby mode to automatically revert to a preferred node. You can override this default behavior by configuring an MC-LAG interface Mode, a link switchover happens only if the active node goes down. In a multichassis link aggregation (MC-LAG) topology with active-standby